Since there isn't an adapter to go from a semi 7-Way to an RV 7-Way the best solution is going to be to install a separate RV style 7-Way on your 2007 International 4400.
You can use installation kit # ETBC7. You may be able to tap into the circuits on the existing 7-Way as long as the turn signals and brake lights are combined on the same circuit. If not then you will have to first install a 4-Way using # 119178KIT.
If the circuits are combined on the existing semi 7-Way then all you... view full answer...
The Reese Super Titan 4000 Trailer Hitch # 38208 referenced in your question is a universal-type hitch that is designed for "C" channel style frames that are approximately 34-34-1/2 inches wide. If this matches the frame on your Kenworth w900 semi-tractor, then this heavy-duty hitch will be a good option.
Otherwise, we do have a nice selection of universal, weld-on hitches available that you can look through that might be a good fit for your w900. The Draw-Tite Ultra Frame Service Body... view full answer...
Yes it will; a truck with air brakes is 100 percent compatible with the Tekonsha Prodigy P3 Trailer Brake Controller # 90195.
The type of brakes your truck has won't matter so long as the circuit that activates the truck's brake wire signal has voltage on it when you press the brakes.
I have added a link below to a video review for you to check out as well of the Tekonsha Prodigy P3 Trailer Brake Controller # 90195. view full answer...
The brake light switch wire on the Tekonsha Primus IQ Trailer Brake Controller - 1 to 3 Axles - Proportional # TK90160 should be positive. That means there will be 12V power running through the wire when the brakes are applied. view full answer...
In order to install a brake controller on your 2015 International 7400, you would need to hardwire one into the vehicle's wiring harness as we do not have a plug-in adapter for you. I recommend using the Tekonsha Prodigy P2 Trailer Brake Controller part # 90885. The Tekonsha Prodigy P2 comes with a pigtail adapter that has 4 wires that will need to be ran for installation.
Red Wire: Stop Light Switch (Cold Side of Brake Pedal)
White Wire: Ground
Blue Wire: Brake Output
Black Wire:... view full answer...
While there isn't a custom fit trailer hitch for your 2008 International 4400 ambulance, there may be an option for you with a weld-on hitch. It just depends on the width of your frame, and one with the correct drop.
- 7" Tall Brackets, 44" Wide Crosstube: Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver # 41990-07
- 16" Tall Brackets, 44" Wide Crosstube: Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver # 41990-16
I have added a link below to the install instructions... view full answer...
Go To Results